Data-Command Lynx - Hardwired Solution
The Data-Command Lynx™ is used to connect equipment via wire and cable. It can monitor 12 digital inputs and 16 analog inputs, and can control 4 digital outputs and 8 analog outputs. To communicate with our Info-Portal, Lynx™ can utilize an existing connection to the internet via cable, DSL, or ethernet connection, or via our cellular solution if a land line is unavailable (as shown below).
Securely Delivering Information
With a hardwired connection, information is passed in a direct manner that is very secure.
*Cellular communications is an option that can be added onto the Lynx product but is not required (See product for details). With an independent modem, Cellular upgrades in the future are less expensive and easier to implement than an integrated solution.
Features
Standard
- Extremely rugged
- Standard Check in time for health reporting
- Report By Exception for immediate Event or Alarm notification.
For pump Monitoring
The Lynx has 12 digitals inputs. All can used for alarming, 3 inputs can be used for pump status monitoring (runtime hours & cycle counts).
Create custom Displays, Trends and Reports for runtime hours, cycle counts.
Alert on excessive runtime, power fail, phase loss, etc.
Integrate with our Asset Management System.
Package Lynx, Modem and Antenna starting at $1,195 each* (volume discounts available)
*excludes monthly Data-Command Info-Portal access fee and Cellular plan.
Specification
Standard Wiring Configuration
12 Digital Inputs (on board)
4 Relay outputs (on board)
16 Analog Inputs (with 4 expansion Module)
8 Analog Outputs (with 4 expansion Module)
Communications:
TCP/IP Ethernet
Fully configurable IP addressing or DHCP
Power Input
- 12 to 28 volts DC or AC
- <400 mA typical
Digital Inputs
- Range 0 to 30 Volts AC/DC
- Logic Low input 0 to 1 Volt
- Logic High input 2 to 30 Volts
- Input Resistance 1.2 K ohm nominal
- Response time – 1 millisecond
- Counter capability 2000 Hz Max (each input)
- Isolation Optically Isolated
- Functions Latching capability – as fast as 1 millisecond
Relay Outputs
- Type SPST, Form A – 1 Normally Open Contact (Two relays are Form C and configurable as Normally Open or Normally Closed to the terminals
- Contact Ratings 1 Amp @ 24 Volts AC/DC
- Pulse Resolution 1 millisecond pulse increments
Analog Inputs
- Quantity: 4
- Range: -10 to + 10 volts DC or 4 – 20 mA or RTD
- A/D resolution: 16 bits (12 bits effective)
- Full Scale Accuracy: better than 1% full-scale
Analog Outputs
- Quantity: 2
- Range: 0 – 10 volts DC or 4 – 20 mA
- D/A resolution: 8 bits
- Full Scale Accuracy: better than 1% full-scale
Environmental
- Type 1 rated
- Operating Temperature: 15ºF to160ºF (-25ºC to 70ºC)
- Storage Temperature: -40ºF to185ºF (-40ºC to 85ºC) / 5 to 95% Non-Condensing
